![]() A schematic diagram is stamped on top of the coolant reservoir, illustrating the minimum and maximum level. In other words, the BMW coolant level is correct if the red float is aligned with the top edge of the filler opening. If the float is sticking up, your BMW coolant level is full. If the float is down, you need to add coolant. Add OEM BMW Engine Coolant mixed at 50/50.The level is full when the bottom of the float reaches flush with the top of the cap. ![]() The red float may have two balls, indicating the low and the second indicating the full level. It will allow residual pressure to release without blowing off the cap.ĭetermine the coolant fluid level. Some BMW models, such as the 3-series, have the coolant expansion reservoir on the engine bay’s right side. This is the typical coolant expansion reservoir location. Locate the coolant expansion tank in the engine bay. As you open the hood, look at the left of the engine bay.Open the hood. Pull the hood release under the dash twice.Allow the engine to cool down. Ensure the engine is cooled down before removing the cap from your coolant reservoir or risk getting burned.Park the BMW in a safe location and set the parking brakes.For this procedure, you will need OEM BMW Engine Coolant recommended in your owner’s manual and mixed at 50/50. Caution: Risk of scalding!įollow these easy steps to check the coolant level on any BMW. Message: Risk of engine damage! Top up the coolant at the earliest opportunity see the owner’s handbook.Coolant warning on, then off after driving.Message on iDrive stating Low engine coolant level.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |